WHAT YOU'LL NEED:

  • OEM SCREWS

    Saved from the previous insert.

  • YOUR NORD INSERT

    Of course.

  • SCREWDRIVER

    HAND-TIGHTEN ONLY.

    DO NOT USE POWER-TOOLS.

    (Your plastic mounts could break)

    Phillips of Flat-Head, depending on screw.

STEP 1: REMOVE THE OLD INSERT

Lift the tailgate to a fully open position.

Locate the screws securing the old tailgate insert in place. These screws are usually located along the perimeter of the insert.

Use a screwdriver to carefully remove the screws, being careful not to strip them. Set these screws aside—you will reuse them. For the 4th gen Toyota tacoma only the front screws will be re-used

Remove the old insert from the tailgate. If it’s been in place for a while, you may need to gently lift or wiggle it free.

For 4th gen Tacoma: Leave OEM insert in place. The Nord insert screws right over top of it.

The 4th generation Toyota Tacoma has a very sensitive tailgate sensor that even comes on with OEM tailgates when accelerating.

The rubber stopper has to either be removed or the tailgate CLOSED/OPEN NOTIFICATION needs to be be muted in your trucks setting.

Here a link to walk you through the settings to turn off the CLOSED/OPEN sensor.

https://www.youtube.com/watch?v=ana7NvGqbVs

If you have any questions or concerns, please email : Info@nordproducts.ca

STEP 2: PREPARE THE NEW INSERT

Check the insert for any protective films or packaging that may need to be removed before installation.

Inspect the fit of the new Nord Products insert against the tailgate to ensure proper alignment.

STEP 3: INSTALL THE NEW INSERT

Position the new insert into the tailgate. Align it so that the insert fits snugly into the tailgate’s insert space. Ensure it is properly seated along the edges.

Secure the insert using the OEM screws that you saved earlier.

  • Start by inserting screws at the top corners or sides to hold the insert in place.
  • Tighten the screws evenly across the perimeter to ensure a secure fit. Do not overtighten to avoid damaging the HDPE insert or stripping the screws.

STEP 4: FINAL CHECK

Verify the alignment of the insert to make sure it’s seated correctly and flush with the tailgate.

Ensure all screws are tight and that the insert is securely attached with no movement.

Close the tailgate and check that the insert stays in place while in use.

STEP 5: READY FOR ACTION

Now that your Nord Products Tailgate Insert is installed, you’re ready to take on any adventure! Whether you’re using it as a filleting table, tool bench, or camping surface, your new insert is built to handle all your needs.